BXZZY - 195438, NEO-SEAL GASKET/RESIN IN SOLVENT (3/4(SUPDAT)
- MSDS: BXZZY
- Manufacturer: ZURN INDUSTRIES HYDRO DIV
- Product Name: 195438, NEO-SEAL GASKET/RESIN IN SOLVENT (3/4(SUPDAT)
- National Stock Number: 8040-00N061638
Product Identification
Product ID:195438, NEO-SEAL GASKET/RESIN IN SOLVENT (3/4(SUPDAT)
MSDS Date:09/01/1993
FSC:8040
NIIN:00N061638
MSDS Number: BXZZY
Responsible Party
ERIE, PA 16514
US
Emergency Phone: 800-424-9300(CHEMTREC)
Info Phone: 814-455-0921
Cage: 70487
Contractor
Telephone: 814-455-0921
Cage: 70487
Ingredients
POLYCHLOROPRENE RUBBER (NEOPRENE)
Fraction By Weight: 35-40%
OSHA PEL N/K
ACGIH TLV: N/K
ALKYL-PHENOLIC RESINS
Fraction By Weight: 25-30%
OSHA PEL N/K
ACGIH TLV: N/K
MAGNESIUM OXIDE (MGO)
CAS: 1309-48-4
RTECS: OM3850000
Fraction By Weight: 1-5%
OSHA PEL 15 MG/M3 PARTICULATE
ACGIH TLV: 10 MG/M3 FUME
ZINC; (ZN) (SARA 313) (CERCLA)
CAS: 7440-66-6
RTECS: ZG8600000
Fraction By Weight: 1-5%
OSHA PEL 15 MG/M3 (MFR)
ACGIH TLV: 10 MG/M3 (MFR)
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
CARBON DIOXIDE; (CO*2)
CAS: 124-38-9
RTECS: FF6400000
Fraction By Weight: 1-5%
OSHA PEL 5000 PPM
ACGIH TLV: 5000 PPM;30000 STEL
CARBON BLACK
CAS: 1333-86-4
RTECS: FF5800000
Fraction By Weight: 1-5%
OSHA PEL 3.5 MG/M3
ACGIH TLV: 3.5 MG/M3
TOLUENE (SARA 313) (CERCLA)
CAS: 108-88-3
RTECS: XS5250000
Fraction By Weight: 37%
OSHA PEL 200 PPM
ACGIH TLV: 50 PPM, S
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
2-BUTANONE; (METHYL ETHYL KETONE) (MEK) (SARA 313) (CERCLA)
CAS: 78-93-3
RTECS: EL6475000
Fraction By Weight: 0.4%
OSHA PEL 200 PPM
ACGIH TLV: 200 PPM;300 STEL
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
ACETONE (SARA 313) (CERCLA)
CAS: 67-64-1
RTECS: AL3150000
Fraction By Weight: <0.05%
OSHA PEL 1000 PPM
ACGIH TLV: 750 PPM;1000 STEL
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
&/OR BONDED WHEN MATERIAL IS TRANSFERRED. NEVER
RTECS: 9999999ZZ
KIDNEY
RTECS: 9999999ZZ
TOLUENE APPEARS ON NAVY LIST OF OCCUP CHEM
RTECS: 9999999ZZ
PROFESSIONALS CONCERNING LATEST HAZ LIST INFO & SAFE
RTECS: 9999999ZZ
DESTROY BY LIQ
RTECS: 9999999ZZ
IN A LANDFILL I/A/W LOCAL, STATE & FEDERAL
RTECS: 9999999ZZ
RESPS UNDER SPECIFIED CNDTNS. (SEE YOUR SFTY
RTECS: 9999999ZZ
IMPLEMENTED TO REDUCE EXPOSURE.
RTECS: 9999999ZZ
IMPERVIOUS CLOTHING & BOOTS.
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYE:CAN CAUSE SEV IRRIT,
REDNESS, TEARING & BLURRED VISION. INGEST:CAN CAUSE GI IRRIT, NAUS,
VOMIT & DIARR, ASPIR OF MATL INTO LUNGS CAN CAUSE CHEM PNEUM WHICH
CAN BE FATAL. INHAL:EXCESSIVE INHA L OF VAPS CAN CAUSE NASAL & RESP
IRRIT,DIZZ, WEAK, FATG, NAUS, HDCH, POSS UNCON & EVEN ASPHY. SKIN:
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:PRLNG/RPTD CONT CAN CAUSE MOD IRRIT,
DEFAT & DERM. CHRONIC:MINOR EMBRYOTOXIC/FETOTOXIC EFTS HAVE BEEN
OBSERVED IN LAB RATS EXPOS TO METHYL ETHYL KETONE BY INHAL AT
LEVELS >1000 PPM (5 TIMES O SHA PEL/TWA) FOR MOST OF GESTATION
PERIOD. OVEREXP TO THIS MATL (OR ITS COMPONENTS) HAS APPARENTLY
BEEN FOUND TO(ING 11)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:EYES:FLUSH W/LARGE AMOUNTS OF WATER, LIFTING UPPER & LOWER
LIDS OCCAS, GET MED ATTN. INHAL:REMOVE INDIVIDUAL TO FRESH AIR.
ADMIN OXYGEN IF BRTHG IS DFCLT. IF BRTHG HAS STOPPED, GIVE ARTF
RESP & GET ME D ATTN IMMED. SKIN:THORO WASH EXPOS AREA W/SOAP &
WARM WATER. REMOVE ANY CONTAM CLTHG. LAUNDER CONTAM CLTHG BEFORE
RE-USE. INGEST:DO NOT INDUCE VOMIT. GET MED ATTN IMMED.
Fire Fighting
Flash Point Method:CC
Flash Point:<32F,<0C
Lower Limits:1.2%
Upper Limits:7%
Extinguishing Media:FOAM OR WATER FOG, DRY CHEMICAL OR CO*2.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:MATL IS HIGHLY VOLAT & READILY GIVES OFF
VAPS WHICH MAY TRAVEL ALONG GROUND/BE MOVED BY VENT & IGNITED BY
PILOT LIGHTS, SPKS, HEATERS, SMOKING, ELEC (SUPP DATA)
Accidental Release
Spill Release Procedures:SM SPILL:ELIM ALL SOURCES OF IGNIT SUCH AS
FLARES, FLAMES (INCL PILOT LIGHTS) & ELEC SPKS. PERSONS NOT WEARING
PROT EQUIP SHOULD BE EXCLUDED FROM AREA OF SPILL UNTIL CLEAN-UP HAS
BEEN COMPLETED. USE S AND, CLAY, EARTH, FLOOR ABSORB THEN
SHOVEL(ING 14)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:KEEP CONTAINERS CLOSED. KEEP AWAY FROM
HEAT, SPARKS & FLAMES.
Other Precautions:CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN
EMPTIED. SINCE EMPTIED CONTAINERS RETAIN PRODUCT RESIDUE (VAPOR,
LIQUID &/OR SOLID), ALL HAZARD PRECAUTIONS GIVEN IN THIS MSDS MUST
BE OBSERVED.
Exposure Controls
Respiratory Protection:IF TLV OF PROD/ANY COMPONENT IS EXCEEDED,
NIOSH/MSHA APPRVD AIR SUPPLIED RESP IS ADVISED IN ABSENCE OF PROPER
ENVIRON CONTROL. (HYDROCARBON VAP RESP/SUPPLIED AIR HOSE MASK IF
NEEDED). OSHA REGS ALSO P ERMIT OTHER NIOSH/MSHA APPRVD (ING 16)
Ventilation:LOCAL EXHAUST OR MECHANICAL EXPLOSION PROOF VENTILATION. NO
SMOKING OR OPEN FLAME.
Protective Gloves:CHEM RESIST GLOVES SUCH AS POLYETHYLENE.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA . TO PVNT RPTD/PRLNG SKIN CONT, WEAR (ING 18)
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
MFR'S TRADE NAME/PART NO:OZ SINGLE USE TUBE). EXPLO HAZ:MOTORS, STATIC
DISCHARGE/OTHER IGNIT SOURCES AT LOCATIONS DIST FROM MATL HNDLG
POINT. NEVER USE WELDING/CUTTING TORCH ON/NEAR DRUM, EVEN IF DRUM
IS EMPTY, BECAUSE PROD/RESIDUE CAN IGNITE EXPLOSIVELY. ALL 5 GAL
PAILS & LGR METAL CNTNRS SHOULD BE GROUNDED (ING 10)
Chemical Properties
Boiling Pt:B.P. Text:110F,43C
Melt/Freeze Pt:M.P/F.P Text:194F,90C
Vapor Pres:38 @ 20C
Vapor Density:4.5
Spec Gravity:0.95 (H*2O=1)
Evaporation Rate & Reference:1.5 (BUTYL ACETATE=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:BLACK VISCOUS LIQUID; AROMATIC HYDROCARBON ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS LIKE LIQUID CHLORINE, STRONG ALKALIES & STRONG MINERAL
ACIDS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY FORM TOXIC MATERIALS, CARBON
DIOXIDE & CARBON MONOXIDE, VARIOUS HYDROCARBONS, PHENOLS, ETC.
Disposal
Waste Disposal Methods:DISPOSAL MUST BE I/A/W FEDERAL, STATE & LOCAL
REGULATIONS .
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.